Zpao Electric Bike Manual Verified Jun 2026

Twist or push the thumb throttle located on the right handlebar. You do not need to pedal in this mode. Keep in mind that heavy throttle usage reduces your total battery range significantly.

Install pedals on their respective sides (marked L and R), tightening firmly with a pedal wrench.

Factory set (Usually 1–50; do not alter unless speed reads incorrectly) Speed Limit

Inspect the cadence sensor located near the bottom bracket. If it is dirty or knocked out of alignment, wipe it clean and adjust it closer to the magnet ring. Zpao Electric Bike Manual

Turn off the bike, wait 10 seconds, and turn it back on. Note the specific error code number for support. Contaminated rotors or pads.

Replace the faceplate and tighten the bolts in a cross pattern (X-pattern) to distribute pressure evenly. Step 2: Front Wheel Attachment

Short-press the M button to cycle through Odometer (ODO), Trip Distance (TRIP), Current Voltage (VOL), and Current Amperage (A). Twist or push the thumb throttle located on

Check the brake levers. Ensure the brake pads clamp tightly before the lever hits the handlebar grip.

Based on the Zpao electric bike manuals product specifications

Use the twist or thumb throttle for instant power without pedaling. Install pedals on their respective sides (marked L

Zpao e-bikes typically require partial assembly upon arrival. Mechanical Steps

If you see E021 (Torque sensor error) on a cadence-sensor Zpao bike, your manual likely has a misprint. Call support.

🚀 : Always double-check the motor cable connection (the big plug near the rear wheel) after shipping or a bumpy ride, as this is the most common cause of "no power" issues. If you tell me the specific model number of your Zpao bike: I can provide the exact P-setting list for that controller.