V2000-c Rfid Access Control User Manual [portable] · Secure

If the keypad beeps twice rapidly, the command was not accepted (e.g., trying to add a duplicate card).

Press * + Master Code + # (Yellow LED lights up or flashes slowly, indicating success).

Card only, Public PIN only, Private PIN only, Card + PIN Current Draw: Active current < 100mA; Idle current < 40mA Relay Output Load: Max 3A

The (often branded under Obo Hands or Youhe ) is a standalone RFID access control keypad used for single-door security. It supports up to 1,000 users and operates via 125KHz RFID cards, 4-digit PINs, or a combination of both. Quick Setup Guide

For further support, consult your distributor for hardware-level repairs. The V2000-c’s simplicity is its strength – there is no cloud to fail, no subscription fee, and no software to crash. Just security that works. V2000-c Rfid Access Control User Manual

If you wired a reed switch to terminal 7 (SEN):

The V2000-C tracks users via numbered from 1 to 2000 . Assigning specific User IDs is highly recommended so you can delete lost cards without needing the physical card in hand. Adding Users (Card or Fob Only) Enter programming mode. Press 1 . Enter a unique User ID (e.g., 0001 to 2000 ) followed by # .

Mount the unit on a flat surface away from extreme heat or moisture. Follow the wiring diagram below to connect the unit to your power supply and electronic lock. Wiring Terminal Definitions: +12V DC (Power) Black: GND (Ground) White: OPEN (Exit Button) Blue: COM (Relay Common) Yellow: NO (Normally Open – for Fail-Secure locks)

Sets the authentication method to require BOTH a valid card AND a valid PIN code for entry. If the keypad beeps twice rapidly, the command

The LED will flash yellow rapidly. You are now in admin mode. All commands below assume you are in this state.

Understanding the technical limits ensures a safe installation and reliable operation. Specification 12V DC ± 10% User Capacity 1,000 users (Cards, PINs, or Card+PIN) Card Reading Distance 3 – 8 cm Compatible Card Type EM (ID) Card (125 kHz) Active Current Idle Current Lock Output Load Alarm Output Load Operating Temperature -10°C to 60°C (14°F to 140°F) Relay Unlock Time 0 – 99 seconds (Adjustable) Wiring and Installation Diagrams

The V2000-C is a standalone RFID access control system designed for single-door security management. It combines an EM card reader with a keypad, allowing entry via card, PIN code, or a combination of both. This manual provides a complete guide to installation, programming, and operation.

Sounds if the door is opened without a valid card or exit button trigger. It supports up to 1,000 users and operates

Check the main power source. Ensure the red (+) and black (-) wires are outputting a stable 12V DC.

: Verify if your lock is Fail-Safe (NC) or Fail-Secure (NO). Ensure the common wire runs through the COM terminal. If using a heavy-duty magnetic lock, power it using an independent access control power box rather than drawing directly from the keypad loop. Issue 3: The keypresses do not register

: The V2000-C is a NON-PoE device. Do not connect the device to a PoE capable Ethernet port as this may cause permanent damage.