Installing a ThyssenKrupp Levant stair lift restores independence and mobility in multi-story homes. While professional installation is highly recommended for safety and warranty compliance, understanding the technical process is essential for troubleshooting, maintenance, and preparation.
Measure the total length of the staircase from the nose of the top landing to the floor of the bottom landing.
Lower the seat assembly onto the chassis seat post. Align the orientation splines and tighten the nylon-locking retention bolt to secure the seat. Connect the wire harness from the seat (seat switch and armrest controls) to the main circuit board on the chassis. 5. Electrical Connections and Charging System thyssenkrupp levant stair lift installation manual
Note: Thyssenkrupp Access (now part of TK Elevator/Access BDD) recommends that installation be performed by a qualified engineer or technician to ensure compliance with safety standards and maintain warranty validity. 1. Overview of the Levant Stair Lift System
The lift is plugged into the power supply to charge the batteries before the first run. Step 5: Final Adjustments and Safety Checks Lower the seat assembly onto the chassis seat post
Clean the staircase and measure the length accurately. The rail should typically be cut to length during the installation phase, usually allowing a 2-3 cm gap from the landing.
Manually ensure the carriage moves smoothly along the track without binding. Step 4: Mechanical Assembly of the Seat thyssenkrupp levant stair lift installation manual
The aluminum rail supports the weight of the carriage and user, housing the gear rack and electrical charging strips.
The Complete Guide to ThyssenKrupp Levant Stair Lift Installation
Lay the rail onto the steps supported by the loose brackets. Use a tape measure to ensure the rail runs perfectly parallel to the wall or banister. Maintain a minimum clearance of 2 inches (50 mm) from the wall.
Temporarily remove the mechanical stop-blocks from the top end of the rail.