: 1.1 kW, typically requiring a 3-phase power supply (380V or 415V). Dimensions : 500 x 550 x 1,700mm (Transport height). Weight : Approximately 180kg to 200kg. 2. Operational Procedures

The control layout of the Strands S68 is minimalist and highly ergonomic. Power and Motor Controls

A: Non-detergent SAE 20 or spindle oil. Do not over-grease.

In the world of heavy iron, knowledge is the ultimate precision tool. Your Strands S68 will reward that knowledge with a lifetime of perfect, vibration-free holes.

Lower the spindle until the drift slot is visible. Insert a standard MT3 drill drift into the slot and tap it gently with a hammer while supporting the tool below to prevent it from dropping onto the table. Table and Head Adjustments

: 600mm distance from the table to the spindle nose when both are at their furthest points.

Tip: When downloading a PDF, ensure it is complete—some free versions omit the exploded diagram.

Never leave the taper-ejection drift key inside the spindle slot. Starting the machine with the drift key inserted will launch it at high velocity.

1.1kW spindle motor requiring a 380V to 415V 3-phase power supply. Operational Guide

model is designed for durability and versatility in industrial environments:

Clean and lightly lubricate the column to ensure smooth vertical head movement. 4. Spare Parts List

Regularly check the sight glass located on the side or front of the headstock. The oil level should sit comfortably in the center of the glass.

Drain the old oil while the machine is slightly warm to ensure contaminants flush out. Replace the drain plug.

Apply a few drops of light machine oil directly to the exposed quill rack and extended spindle.