Stenhoj Ds2 Manual -

Note: On older mechanical synchronized models, ensure the safety pawls or synchronization cables are operating smoothly without binding.

The manual covers the full lifecycle of the equipment, including: Installation Requirements : Detailed specifications for foundation depth

: Stenhøj A/S.

Measure the distance between the two nuts using the physical wear indicator or a caliper as specified in the manual. stenhoj ds2 manual

Never exceed the rated capacity (typically 2,000kg to 3,500kg for DS2 variants).

Are you performing a or troubleshooting an issue ?

Press the "UP" button. The lift will rise on both sides. Note: On older mechanical synchronized models, ensure the

Requires specialized chemical or through-bolts with a minimum strength rating of 8.8.

The lift was stuck in a safety lockout. The ramps were raised, but the locking mechanism hadn't disengaged, meaning the car currently trapped atop it—a very expensive, very impatient customer’s vintage Porsche—was effectively a permanent fixture of the garage ceiling.

Usually indicates a need for lubrication on the screw or worn-out grease on the carriage sliders. Never exceed the rated capacity (typically 2,000kg to

The Stenhoj DS2 manual is available in various formats, including:

: It strongly recommends using authorized partners for installation due to the precision required for electronic synchronization and alignment. Autosfera.lt Critical Maintenance Insight User feedback highlights that the manual’s section on load and safety nuts

Drive the vehicle centrally between the posts. The center of gravity must align with the lifting spindles.

Inspect the safety nuts for wear (very important for electro-mechanical lifts). Check electrical connections.