Spreadtrum Imei Tool V41 Updated !exclusive!

: Compatible with both Diag Mode (universal factory protocol) and Normal/MTP Mode .

Compatible with older SC-series chipsets and newer Unisoc processors.

Always try to back up your device's NVRAM data before changing any identification numbers. Troubleshooting

Press or F7 to select "Disable driver signature enforcement". How to Use Spreadtrum IMEI Tool v4.1 (Step-by-Step) spreadtrum imei tool v41 updated

: Most devices require booting into "Diag Mode" to allow write access. This often involves connecting the device while holding specific volume keys. Configure the Tool : Launch WriteIMEI.exe . Select the correct COM Port identified in Device Manager.

The Spreadtrum IMEI Tool v4.1 is a Windows-based application designed specifically for devices powered by Spreadtrum/Unisoc chipsets. This tool allows users to read, write, or repair the , Bluetooth, and Wi-Fi addresses.

Functions without expensive hardware dongles. Supported Devices : Compatible with both Diag Mode (universal factory

The tool will begin the flashing process. Once completed, you will see a green message.

This could be due to an incorrect connection mode, a missing baseband, or a corrupted NVRAM partition. As a first step, ensure you have flashed a compatible firmware (PAC file) to restore the baseband.

Follow these instructions carefully to rewrite your device's identity records safely. Step 1: Preparation Back up all vital data on your smartphone or tablet. Download and install the on your PC. Restart your computer to finalize driver installation. Troubleshooting Press or F7 to select "Disable driver

Type the second valid 15-digit number into the input field (if applicable). Step 4: Connecting the Device Click the Start or Write button on the tool interface. Turn off your mobile device completely.

Turn off your mobile device completely. Hold down the device's specific Boot Key (usually or Volume Up ). While holding the key, connect the phone to the PC using the USB cable. Release the key as soon as the software detects the device and the progress bar begins to move. Step 6: Complete the Process

Navigate to the extracted folder and right-click , then select Run as Administrator .

Ensure you are using the correct Diag Mode. Reinstall the SPD drivers and try using a different USB port.