Raysharp Dvr Password Reset -

Enter this code into your DVR within 5 minutes to prompt a new password creation screen. 4. Hardware Hard Reset (Opening the Case)

Here is the complete, step-by-step guide to resetting your Raysharp DVR password. 1. Try the Default Credentials First

Run the software to detect the connected DVR.

Release the button. The system will reboot with factory default settings. Method B: Shorting the Jumper Pins raysharp dvr password reset

A security code will be sent to the email address registered during the initial setup. Enter this code to create a new password. 4. The Hard Reset (Hardware Level)

Before attempting technical resets, try the official default credentials. Many Raysharp DVRs use standard factory settings if they were never updated during installation. admin (always lowercase) Password: Leave it completely blank Alternative Passwords: 000000 , 111111 , 123456 , or 888888 Method 2: The Motherboard CMOS Battery Jump

Short the two pins with a screwdriver or hold the button for 10–30 seconds while powering the device back on. Enter this code into your DVR within 5

Remember: Resetting the password does not delete your footage. Your hours of recorded video remain intact on the hard drive. Only the keys to the castle are being replaced. If all else fails, contact Raysharp’s official support at with your device serial number (S/N) and date code.

Before attempting a full reset, check if the device is still using factory settings. Common default combinations include: admin

What are currently displayed on your monitor screen? The system will reboot with factory default settings

Tie a valid email address to the admin account for automated password recovery.

This comprehensive guide covers every proven method to reset your Raysharp DVR password and regain access to your security camera system. Method 1: Try the Factory Default Passwords