Narishige Pc10 Manual New Official

: Includes two types of weights (light and heavy) for fine tension adjustment. Technical Data Heater Level : 100 = 2.5V heater voltage. Power Source : 100V–240V AC (±5%). Dimensions : W205 x D190 x H185mm; Weight: Approx. 6.0kg. 2. Safety & Handling Precautions

1-Stage Pull: Heats the glass and pulls it apart in one continuous motion. Best for large-tipped tools like microinjection needles.

Remove the finished pipettes vertically to prevent touching the ultra-fragile tips against the metal frame or heating coil.

When unboxing a new PC-10, ensure all components are present, including the main unit, weight, glass holder, heater coils, and the instruction manual.

The Narishige PC-10 is a high-precision vertical puller designed to produce long, thin microneedles or firm microelectrodes. It operates on a vertical axis, using the gravitational force of internal weights to pull heated glass. narishige pc10 manual new

Attach the designated weights to the bottom of the sliding shaft. The standard configuration uses a main weight and sub-weights to control the initial gravity pull.

Adjust the dial to soften the glass without melting it completely during the first drop.

The front panel of the PC-10 features analog dials and toggle switches designed for precise manual adjustments. Understanding these controls is vital for reproducible results.

Detailed operational settings and maintenance tips can be found in the Narishige PC-10 User Manual. : Includes two types of weights (light and

Increase the Heater 2 setting slightly, or increase the pulling weight.

: Use the Mode-selector knob to choose between STEP 1 (one-stage) or STEP 2 (two-stage).

Check that the platinum heating element is centered. The glass capillary must pass directly through the middle of the coil loop without touching the metal walls.

Explain how to optimize the PC-10 settings for (10-100 MΩ). Dimensions : W205 x D190 x H185mm; Weight: Approx

Rotate the bottom switch 90 degrees clockwise to clear the weight path. Start Switch again. The unit will heat at the NO. 2 HEATER level and pull the glass until it separates. NARISHIGE WEB NEWS Reference Settings Examples Application First Pull Distance Thin/Long Pipette 3 (2L, 1H) Firm/Stubby Tip 4 (2L, 2H) Safety & Maintenance Tips No.051 Setting Values in the PC-10 Puller (Revised)

The workshop smelled of solvent and warm plastic. Under a single swinging lamp, Lena unfolded a brittle manual labeled NARISHIGE PC-10—its corners softened by oil and years—then, with the care of someone handling a relic, set it beside the device.

Install an acrylic draft shield around the puller and plug the unit into a voltage stabilizer. Preventive Maintenance

If the heater coil becomes brittle or fails to heat (Error E_99), it must be replaced. Environment: