Hmi Backup - Mcgs

Reformat the USB drive to FAT32. Try using an older USB 2.0 drive under 16GB.

Never overwrite a backup. Use filenames like MixerProject_v2.0_2025-03-15.mcgsx .

[ MCGS HMI Screen ] <======= ( Ethernet / USB Cable ) =======> [ Laptop with MCGS Software ] || \/ [ .ALX / .MCE Backup File ] Connection Methods

| Method | Speed | History logs saved? | Automation | Security | |-------------|-------|---------------------|------------|----------| | USB | Fast | Yes (full image) | Manual | Medium | | FTP/Ethernet| Medium| Yes (folder copy) | Cron job | Low | | Cloud | Slow | Yes | High | High (TLS)| | Dev PC copy | N/A | No | Manual | High | mcgs hmi backup

: Maintain comprehensive documentation of the backup and recovery procedures. Ensure that personnel are trained on these procedures to facilitate quick and effective recovery in case of an emergency.

Link your PC to the MCGS HMI using an Ethernet cable or USB programming cable.

Wait for the progress bar to reach 100%, then safely remove the flash drive. Method 2: PC-to-HMI Upload using McgsPro Software Reformat the USB drive to FAT32

: Launch the MCGS configuration software on your computer. Initiate Upload : Navigate to the File menu and select Upload Project .

Your custom-designed screens, scripts, communication parameters, and alarm configurations represent hours of engineering work.

Note: If the original programmer ticked the "Prohibit Project Uploading" security option during development, you will only be able to back up compiled runtime data or historical databases, not the editable source code. 4. Troubleshooting Common Backup Failures Use filenames like MixerProject_v2

Choose your connection medium (USB or Network/TCP) and click "Connect". Download/Upload Check:

There are two primary ways to perform a backup of an MCGS HMI: via the (PC-based) or via a USB/SD Card (directly from the unit). 1. Using MCGS Embedded Configuration Software (Upload)

A FAT32-formatted USB flash drive or SD card (ideally 32GB or smaller for maximum compatibility with older CE-based or Linux-based MCGS firmware).

You can only retrieve an editable project from an MCGS HMI if the original programmer enabled the "Download Source File" (or "Prohibit Upload" unselected) option during the initial deployment. If this option was disabled, you cannot recreate the editable .mce project directly from the hardware screen; you can only perform a full image backup via a USB drive for exact cloning. Method 1: Backing Up via USB Flash Drive (No PC Required)