Connect the operator to the power supply, following the wiring diagram provided in the full 10-page manual.
After correctly assembling the rail and operator, proceed as follows:
Before performing any installation or maintenance, ensure the power supply is disconnected and locked out. Connect the operator to the power supply, following
at the rail head to secure internal chain.
: The PR70 ships directly out-of-the-box with a pre-wired, factory-tested Schuko plug power cord connected to the onboard transformer. Do not cut, shorten, or structurally alter this cord , as doing so voids the warranty and can compromise electrical grounding safety. 6. System Programming & Calibration How to program Probo XL : The PR70 ships directly out-of-the-box with a
Section 7: General Electrical Overview and Professional Installation Power Connection Requirements
Ensure there is sufficient clearance for maintenance and manual release operations. System Programming & Calibration How to program Probo
Test the manual release by pulling the cord to disengage the carriage from the drive system, ensuring the door can be moved freely by hand.
: Replace CR2032 transmitter battery and straighten antenna.
The Life PROBO PR70 is an irreversible electro-mechanical operator with a built-in encoder and electronic unit. The range consists of two different power models: PR70-07 / PR70-DL and PR120-07 / PR120-DL. Motion transmission is performed through chain or belt-driven retainer runners. The retainer runner includes a release mechanism to allow manual door movement when needed.
Connect the operator to the power supply, following the wiring diagram provided in the full 10-page manual.
After correctly assembling the rail and operator, proceed as follows:
Before performing any installation or maintenance, ensure the power supply is disconnected and locked out.
at the rail head to secure internal chain.
: The PR70 ships directly out-of-the-box with a pre-wired, factory-tested Schuko plug power cord connected to the onboard transformer. Do not cut, shorten, or structurally alter this cord , as doing so voids the warranty and can compromise electrical grounding safety. 6. System Programming & Calibration How to program Probo XL
Section 7: General Electrical Overview and Professional Installation Power Connection Requirements
Ensure there is sufficient clearance for maintenance and manual release operations.
Test the manual release by pulling the cord to disengage the carriage from the drive system, ensuring the door can be moved freely by hand.
: Replace CR2032 transmitter battery and straighten antenna.
The Life PROBO PR70 is an irreversible electro-mechanical operator with a built-in encoder and electronic unit. The range consists of two different power models: PR70-07 / PR70-DL and PR120-07 / PR120-DL. Motion transmission is performed through chain or belt-driven retainer runners. The retainer runner includes a release mechanism to allow manual door movement when needed.