Lenel Lnl-3300-m5 Installation Manual Upd Verified -

Connect the opposite end to a managed network switch with direct routing capabilities to the host OnGuard server. Configuration and Jumper Settings

Communicates through the backplane to support up to 32 board addresses. 2. Technical Specifications Requirement / Specification Operating Voltage 12 VDC ± 10% Current Consumption 300 mA maximum Primary Communication On-board 10/100Base-T Ethernet Secondary Port External RS-485 (2-wire) for multi-unit communication Dedicated Inputs 2 unsupervised (Cabinet Tamper and AC Power Fail) Environmental Operating: 0° to +70°C; Humidity: 5–95% RHNC 3. Installation Steps

: The default admin/password account is only valid for five minutes after DIP switch 1 is turned ON. It is critical to create at least one persistent user account before setting switch 1 back to OFF.

Ensure the nylon or metallic standoffs inside the Micro/5 enclosure are secure and free of debris. Lenel Lnl-3300-m5 Installation Manual UPD

The LNL-3300-M5 features onboard DIP switches and jumpers to establish hardware operational modes and addressing profiles. DIP Switch S1 Settings

To commission the panel:

Press down evenly until the board connects firmly into the backplane connectors. Connect the opposite end to a managed network

Whether you are using a for this panel

For OSDP readers (recommended):

This manual covers out-of-the-box hardware mounting, M5 backplane integration, initial network configuration, and best practices for upgrading legacy panels. Understanding the Lenel LNL-3300-M5 The LNL-3300-M5 Ensure the nylon or metallic standoffs inside the

Connect the power source to the primary power input terminal block (typically labeled VIN+ and VIN-).

Before applying power, properly configure the board using the onboard switch matrix. S1 DIP Switch Configurations

Do not mix legacy CASI M Series boards with Lenel M Series boards in the same controller. 4. Initial Configuration To configure the LNL-3300-M5 via its web interface:

Binary representation of the address (Switch 1 is lowest value, Switch 5 is highest).

Open OnGuard system administration, add an Intelligent Controller, and input the matching IP address to initiate the secure TLS handshake. To ensure your system operates correctly, let me know: Which firmware version you are currently running?