Ivoclar Programat P100 Manual English Jun 2026

: Connect the heater plug, vacuum hose, and thermocouple into their respective sockets on the furnace base. Power & Vacuum

The is a hallmark of precision in dental laboratory technology, designed to provide consistent, high-quality firing results for ceramic materials. Whether you are a seasoned dental technician or new to Ivoclar furnace operation, mastering the Programat P100 requires a clear understanding of its operation, maintenance, and programming protocols.

: If needed, adjust the temperature in small increments (1–2 degrees) at a time. 4. Maintenance and Cleaning ivoclar programat p100 manual english

You can customize parameters such as holding temperature ( ), temperature increase rate ( ), and holding time ( ) via the menu buttons. 3. Temperature Calibration (Silver Test)

Before powering on the unit, ensure the environment is suitable for high-temperature equipment. : Connect the heater plug, vacuum hose, and

Once parameters are verified, place your dried ceramic object on the firing tray using furnace tweezers. Press the green key. The furnace will automatically control the lift position, ramp up the temperature, engage the vacuum, hold at peak temperature, release the vacuum, and open the furnace head upon completion. 4. Calibration and Silver Wire Test

Place the furnace on a level, stable surface, away from direct sunlight, vibrations, and excessive heat sources. : If needed, adjust the temperature in small

: Switch the unit on using the main power switch at the rear. The display will light up and the furnace head will usually perform a self-test. 2. Basic Operation & Menu Navigation uses a membrane-sealed keypad for navigation.

Set the entry temperature (usually 400°C–500°C).