: Verify that the latest drivers are installed. Outdated drivers can cause connectivity issues.
: Clone devices sometimes have poor soldering, and the epoxy coating used to hide components can lift chips from the board over time. Reflowing the MCU and re-soldering lifted components has successfully revived bricked devices.
Navigate to and click Restart .
A "Not Connected" message can also be a protective error if the unit is losing power.
A: You likely opened the software while it was connected to the internet, and it automatically updated, causing the "clone" firmware to lock up. iprog programmer not connected new
: Connect the device directly to your PC's motherboard ports (on the back for desktops) rather than a USB hub, as hubs often provide insufficient power.
: Faulty or low-quality USB cables can cause intermittent connection errors. Test with a known working high-quality cable to see if the status changes. Serial Number Mismatch : Verify that the latest drivers are installed
The "Programmer is not connected" error with iProg+ devices typically stems from driver installation failures, power supply issues, or hardware component defects common in clone units.