This switch is located on the left side of the machine, near the power cord. Unplug the power cord directly from the wall outlet.
Enter the sub-code (to reset the developer counter) or 01 (to reset the maintenance counter). Press the Start button.
Here are solutions to some common problems users encounter:
After replacing high-wear components like the drum cartridge, transfer unit, or fusing unit, the maintenance counter should be reset. Ideally, the machine automatically detects new parts and resets the counter when you turn it on. However, if it doesn't, or if the machine isn't ready after a part change, you can manually clear it with SIM 20-01. how to reset sharp ar-6020
After consulting the user manual, John discovered that a reset might be just what the machine needed. He decided to follow the steps to reset the Sharp AR-6020.
Reconnect the cable directly to the wall outlet (avoid extension cords) and flip the power switch back on. 2. Accessing Sharp AR-6020 Simulation Mode
Alternative sequence (depending on firmware revision): This switch is located on the left side
If the "toner cartridge replacement required" indicator stays on after the replacement, . This will restart the toner feeding process, which takes a couple of minutes to complete. Once finished, the indicator will go out.
The machine will initialize and clear the error state. If successful, turn the main power switch off, wait 10 seconds, and turn it back on.
The display should now be blank or show "0-0," indicating you are in Simulation Mode. Using the number pad, type (for Trouble Reset) or (for Error Reset). Press the [Start] (Print) button. Press the Start button
Type (sub-code for total initialization) and press Start .
: On the control panel, quickly press the following sequence: . (Note: Some variants use [Interrupt] [Interrupt] Input Program Code : Use the numeric keypad to enter Execute Reset : Press the
If the machine is exhibiting strange, unpredictable behavior, or if you are preparing it for a new network, a factory reset might be necessary. Press the System Settings key on the operation panel.
Toggle the main switch back on, wait for the green status light to stop flashing, and then press the panel power button. Resetting Error Codes via Simulation Mode