Before downloading any software, you must confirm that your USB drive actually uses the Firstchip FC1179 controller. Using the wrong tools can permanently ruin the device.
Before attempting a flash, you must confirm that your drive uses the FC1179 controller. Using the wrong firmware will permanently damage the drive. Recommended Identification Tools:
Right-click on FirstChip_MpTool.exe (the name may include version numbers like FirstChip_MpTool_20211024 ) and select . 2. Connect Your USB Drive Firstchip Fc1179 Firmware
The Firstchip FC1179 is a low-cost, mass-produced USB 2.0 and USB 3.0 NAND flash controller found in budget and mid-range USB drives from brands like PNY, Lexar, Kingston (on older models), and countless generic "no-name" drives from platforms like eBay and AliExpress.
Re-open settings, increase the ECC allowance, change from "High Speed" to "Stable" mode, and run the process again. Before downloading any software, you must confirm that
Warning : This will take time (up to an hour for 16GB–32GB) and . Do not unplug the drive during this process. ⚠️ Pro-Tips for Success
Open the extracted folder and run as an Administrator. 2. Connect the Drive Using the wrong firmware will permanently damage the drive
: For newer 2024 batches, try FC1179 MpTools V1.0.7.2 .