Connects to the permanent auxiliary negative power output from the control panel.
Ensure the tamper switch mechanism is correctly aligned with the mounting surface to allow for proper wall-tamper detection. 2.2 Wiring Connections (Terminal Block Breakdown) The Rapier G3S range, including the 7422-SFG-G3F Go to product viewer dialog for this item. , uses standard terminal configurations:
Installation should only be carried out by a qualified security technician. 3.1 Components 1x Stainless Steel External Unit. 1x Internal Electronics Module. 1x Battery (usually rechargeable). Mounting Screws and Wall Plugs. 3.2 Mounting the Unit
The is a high-specification external siren sounder bell box designed specifically for ADT alarm systems . It is a Security Grade 3 device typically used in installations requiring high levels of security protection. Key Technical Specifications elmdene 7422-sfg-g3f manual
Configure jumpers if applicable to choose between pulsed or steady strobe, or to set sounder duration.
This comprehensive installation and technical manual outlines the step-by-step wiring configurations, link options, and maintenance protocols required for optimal operation. Technical Specifications
The installers' community has documented the functions of each terminal on the Elmdene 7422 series: Connects to the permanent auxiliary negative power output
Elmdene cannot supply the manual directly, as contractual rights are owned by ADT.
This comprehensive guide serves as an installation and programming manual, covering technical specifications, wiring configurations, commissioning steps, and troubleshooting procedures. Technical Specifications
Reset the alarm panel. If the issue persists, trigger the bell while reading the voltage across the internal battery pack; if it drops below 6V DC under load, replace the rechargeable battery array. 1x Battery (usually rechargeable)
Microprocessor-controlled with self-test functions every 24 hours to check battery and piezo health. Installation & Maintenance Notes
Fasten the 7422-SFG-G3F module into its designated mounting slots using the provided chassis screws. 4. Wiring and Testing
Route the multi-core alarm cable through the integrated rear cable entry grommet before screwing the backplate flat against the wall.
Put the security control panel into .
Inspect the front lid microswitch and the rear wall tamper plunger. Ensure the wall surface is flat enough to completely depress the rear plunger. Check the integrity of the wiring core assigned to the RTN circuit.
