Regardless of which "Big Shot" you are looking to set up, achieving optimal performance requires a precise installation. This comprehensive guide breaks down the installation, calibration, and safety protocols for the most common Big Shot systems on the market.
sensor connectors. Unplug them, typically located behind the right side panel.
Forcing the handle can snap the internal gear drive. big shot install
The base unit is not level or internal rollers are misaligned. Re-level the base and check internal alignment screws.
is ready to go almost immediately. The only real "assembly" required is attaching the handle: Remove the protective cap from the handle crank. Slide the handle onto the shaft. Secure it using the provided hex nut and tool. Regardless of which "Big Shot" you are looking
Whether you are scaring pigeons out of a garden or competing in the growing sport of slingshot field target, take your time with the install. Double-check every knot. Measure twice. Wrap tight. A weekend spent mastering the big shot install will pay dividends for years in every shot you take.
Safety first. Always wear impact-rated shooting glasses. If you hear a "crack" during your draw, release the tension slowly and replace the bands immediately. Happy shooting. Unplug them, typically located behind the right side panel
Ensure you did not accidentally leave the Thin Die Adapter in place while using a thick Bigz die or a 3D embossing folder. The Machine is Cutting Incompletely
: Elevate the vehicle safely. You will need to access the shifting box located under the cabin.
Once the bands are physically attached, you are not done. You must "tune" the setup.
Wafer-thin dies require the maximum thickness from your platform to reach the rollers.