Annoy Tools Cnc Board Manual Pdf _hot_

Plug the ribbon cable from the handheld controller into the OFFLINE port. Note: Disconnect the USB cable from your computer when using the offline controller. 4. Initial Software Configuration

The manual shows you need to set $5=1 (invert limit pins) if you use normally open switches. Also check that the switches connect to GND and the signal pin, not 5V.

Pre-flashed with GRBL 1.1f for stable performance. annoy tools cnc board manual pdf

Annoy Tools boards run on GRBL firmware. To communicate with the board, you will need a G-code sender like Candle, Universal Gcode Sender (UGS), or LaserGRBL. Set your software to 115200.

Connect the 12V DC power supply. Note: Ensure the power switch is off before plugging in. Connecting to Software (Candle) Plug the ribbon cable from the handheld controller

To ensure accurate movement, you must calibrate the steps per millimeter (

Check microstep jumper settings. Ensure the "EN" pin is not forced low. Increase Vref slightly using the potentiometer. Initial Software Configuration The manual shows you need

Motors Vibrating but Not Moving: This usually indicates a loose wire in the 4-pin connector or a current limit that is set too low on the stepper drivers.

A "sender" is the software on your computer that sends G-code commands to the CNC controller. Annoy Tools boards are compatible with several popular, free options: