Amada Digipro Manual Jun 2026

Follow these steps to use the DigiPro during a production or setup run: Step 1: Perform the Test Bend

Place the device in the docking station; replace batteries if applicable. Line of sight blocked or weak signal

Ensure tool is perpendicular to the bend line. Clean the workpiece surface. Broken data cable or dead wireless battery.

accuracy specification. Calibration should be performed at the start of every shift. amada digipro manual

The most reliable way to obtain the correct manual is to obtain the complete documentation package for your specific Amada press brake model. Here are the most effective methods:

The is a specialized digital infrared protractor designed to enhance the precision of sheet metal bending on Amada press brakes . By serving as a bridge between the physical part and the machine's computer numerical control (CNC), it significantly reduces the need for trial-and-error bending. Overview of the DigiPro System

Perform a formal calibration check against your reference block and log the deviation results. Follow these steps to use the DigiPro during

Precise calibration is essential for maintaining accuracy. Operators must: Press the moving square of the protractor against its stop.

Two precision-ground steel blades that sit flat against the internal flanks of the bent workpiece.

Holds the device when not in use and keeps the internal battery charged. How It Works The operator performs a test bend on the press brake. Broken data cable or dead wireless battery

Line-of-sight obstruction, dirty IR lens, or low battery power.

Ensure the receiver eye mounted near the press brake controller is not blocked by sheets, crane chains, or tooling cabinets.

Always store the DigiPro in its original padded protective case when not in use. Never leave it resting on the press brake bed where vibrations or falling parts can damage it.

Open the blades fully until they sit completely flat on the surface plate.